Ethernet Network RJ45 Surge Protector
Item No.: SAGT-RJ45-E100
Category:
Lightning Arrester
Keywords:
Contact
Product Description
Description
Ethernet Surge Protector (Surge Protector) is a surge protection device (SPD) that uses RJ45 cables (CAT6/CAT5/CAT5e) to plug in to prevent damage to electronic network equipment.
The Ethernet network surge protector can work in both directions (input/output), so the source input signal cable can be connected to either side. It doesn't matter which side the device is on, but the surge protector only protects the network device on the other side where the surge occurs. In order to protect the equipment on both sides, it is recommended to have a surge protector at each end of the RJ45 cable in the network topology.
Details
Ethernet Network RJ45 Surge Protector
Insertion Loss: ≤0.3 dB
Working Voltage(V)：5V
Max Continuous Working Voltage(V): 6V
Nominal Discharge Current (8/20us): 5KA
Max Discharge Current (8/20us): 10KA
Key Features
Response Time： ≤1 ns
Transmission Speed：100 Mbps
Protection Mode：1.2.3.6 (4 cores)
Protection Route：Single Route
Working temperature (℃）：- 40 to +85
IP rate：IP20
Part Number
No Date
Documentation & Downloads
No Date
Feedback
WRITE A MESSAGE TO US
Related Products
No Date